Honeywell Enraf 1010 CB Programming Manual page 37

System (2)
Stop Bits Selects the number of stop bits for the communications interface.
Unit Address Selects the unit address of the Port for computer communications.
Terminal Automation
4 - 21
Constraints: Baud rate is fixed to 9600 for NEXWATCH and
Select one of the following options:

300

600

1200

2400

4800

9600*

19200

38400
Parity Selects the parity for the communications interface.
Constraints: Parity is fixed to None for NEXWATCH and
Select one of the following options:

Odd*

Even

None
Constraints: Stop bits is fixed to One for NEXWATCH and
Select one of the following options:

1*

2
Constraints: Only if Comms Device = Computer
Enter a value in the following range:

1 to 31 (1*).
4.7.2 Terminal Automation Mode
Use this sub-menu to set the operating mode for terminal automation.
Selects whether the instrument will use load details as entered by the
Mode operator, or request load details from the Terminal Automation System
(TAS).
Select one of the following options:

Standalone*
Model 1010 Application Pack CB
Programming Manual
INTELLIGENT ADDITIVE.
INTELLIGENT ADDITIVE.
INTELLIGENT ADDITIVE.
This address is not used if the port is assigned as
intelligent additive or NEXWATCH.
Part No.: 4418024 - Rev. 1