Honeywell Enraf 1010 CB Programming Manual page 62

Metering Lines (4)
Breakdown Density Allows enabling or disabling the breakdown density.
Meter n
Breakdown Density
Manual Density Allows entering of the manual density.
Meter n
Pressure Correction
6 - 8
Enter a value in the following range:

4 mA setting to Max range in Table 6-2 on page 6-7.
Constraints:

Only available when you use the Weights and Measures switch on
the instrument to enter programming mode.

Only if density correction is enabled
Select one of the following options:

Enable

Disable*
Allows entering the breakdown density. This value is used for correction
calculations if the density probe fails.
Constraints:

Only available when you use the Weights and Measures switch on
the instrument to enter programming mode.

Only if density correction and breakdown density is enabled
Enter a value in the following range:

4 mA Density Setting to 20 mA Density setting
Constraints:

Only available when you use the Weights and Measures switch on
the instrument to enter programming mode.

Only if density correction is disabled.
Enter a value in the following range:

Refer to Table 6-2 on page 6-7.
Enable to take pressure correction into account when calculating net
volumes.
Constraints:

Only available when you use the Weights and Measures switch on
the instrument to enter programming mode.

Only if Commodity Type selected is Crude Oils (A), Refined (B) or
Lube Oils (D) or NGL and LPG (E) with Regulated PM not used.

Only if 4-20 mA input is available after configuring the temperature
and density analog probes.
Select one of the following options:

Enable

Disable*
Model 1010 Application Pack CB
Programming Manual
Part No.: 4418024 - Rev. 1