Table of Contents
Advertisement
Metering Lines (4)
K-Factor Type Use to select the K-Factor type for this meter input. For more
K-Factor Use to set the K-Factor for the flow meter (normally stamped on the
6 - 2
6.2 Configure Line n (4n)
6.2.1 Description
Use the Configure Line menu to enter the general parameters relating
to the metering line such as K Factor, Signal Type, and temperature and
pressure correction.
6.2.2 Name
If enabled allows an 8 character alphanumeric description to be entered
for the meter, for example "METER 1", "METER 2", "XYZ".
Constraints: 8 character alphanumeric
6.2.3 K Factor
Constraints: K-factor prompts are only available when you use the
information, see the 1010CB Software Manual.
Select one of the following options:
Linear*
Single K-Factor for the whole flow range
Non-Linear
Multiple K-Factors based on different flow rates
data plate of the flow meter) in pulses/unit.
Constraints: Linear only.
Enter a value in the following range:
0.001 to 50000.0 (1.0*)
Model 1010 Application Pack CB
Programming Manual
LINE N
LINE 1
- ACCUMULATED TOTALS
- ACCUMULATED TOTALS
- METER FACTOR
- METER FACTOR
- CON
- CON
- NAME
- NAME
- K FACTOR
- K FACTOR
- SIGNAL TYPE
- SIGNAL TYPE
PRESS ENTER TO SELECT
PRESS ENTER TO SELECT
Weights and Measures switch on the instrument to enter
programming mode.
41
41
Part No.: 4418024 - Rev. 1
Hide quick links:
Advertisement
Table of Contents
