Honeywell Enraf 1010 CB Programming Manual page 20

System (2)
LAMP STATUS BOOT No selection possible for BOOT state.
LAMP STATUS IDLE Allows the operator to select the lamp status for idle.
LAMP STATUS
AUTHORISATION
LAMP STATE WAIT ACK Allows the operator to select the lamp status for wait ACK
LAMP STATE WAIT
START
4 - 4
Constraints: Only available when you use the Weights and Measures
switch on the instrument to enter programming mode.
RIT is available with 1 arm or 2 arm systems only.
The following lamp status is available for boot condition:

ALL OFF
Select one of the following options:

ALL OFF

RED STEADY*

RED FLASHING

AMBER STEADY

AMBER FLASHING

GREEN STEADY

GREEN FLASHING
Allows the operator to select the lamp status for authorization.
Select one of the following options:

ALL OFF

RED STEADY

RED FLASHING

AMBER STEADY*

AMBER FLASHING

GREEN STEADY

GREEN FLASHING
Select one of the following options:

ALL OFF

RED STEADY

RED FLASHING

AMBER STEADY

AMBER FLASHING*

GREEN STEADY

GREEN FLASHING
Allows the operator to select the lamp status for wait start
Select one of the following options:

ALL OFF
Model 1010 Application Pack CB
Programming Manual
Part No.: 4418024 - Rev. 1