Honeywell Enraf 1010 CB Programming Manual page 25

System (2)
Master Authorisation Use the Display key to select the type of authorization the operator will
Master ID TAS Override If enabled, allows the use of a Master ID to override the actions of a
NOTE:
Hardware Test Via '8'
4 - 9

NONE*
Item not displayed

PIN
Enter vehicle pin > _

TOUCH
Present vehicle touch key

RF ID
Present vehicle RF ID card

NEXWATCH
Present vehicle NEXWATCH card
use to identify themselves as the master to the instrument.
Select one of the following options:

NONE*
Item Not Displayed

PIN
Enter Master Pin > _

TOUCH
Present master touch key

RF ID
Present master RF ID card

NEXWATCH
Present master NEXWATCH card
Terminal Automation System, and allows the instrument to operate in
stand-alone mode for one loading sequence. If another load is required
the Master ID has to be entered again. See the following note for more
details.
Constraints: Only if Master Authorisation is not set to None.
Select one of the following options:

Disable*

Enable
When load scheduling is enabled, or remote authorization is enabled in
standalone mode and communication with the TAS fails, the site manager
can enter a Master ID to override the communications failure to allow one
complete load. Once the load is complete the unit will revert back to its
original mode. This can be done as long as the communications failure
exists.
If enabled, allows entry to the hardware test mode using the '8' key and
Key the appropriate password. See "Entering Hardware Test Mode" on page
5-1 of the 1010CB Service Manual.
Model 1010 Application Pack CB
Programming Manual
Part No.: 4418024 - Rev. 1