Authorisations/Pins - Honeywell Enraf 1010 CB Programming Manual

System (2)
NOTE:
Setup Password The password required to access any of the parameters in Setup Mode
Manager Reset The password required to reset the system after an Emergency Stop or
PIN Password The password required to enter or edit PIN and touch key numbers
Personnel Authorisation Use the Display key to select the type of authorisation that operators will
Vehicle Authorisation Use the Display key to select the type of authorisation required to
4 - 8

DD/MM/YYYY *

MM/DD/YYYY

YYYY/MM/DD
Slip commands always retain the same date format as laid out in the
Software Protocol Manual regardless of this menu setting.

4.2.8 Authorisations/Pins

Use the Authorisations/Pins sub-menu to set passwords, PINs and
other methods of authorisation access to the instrument.
(4 to 8 digits).
Enter a value in the following range:

0000 – 99999999 (6789*).
other system fault. (4 to 8 digits).
Enter a value in the following range:

0000 – 99999999 (9876*)
directly within the instrument. (4 to 8 digits).
Select one of the following options:

0000 – 99999999 (1234*)
use to identify themselves to the instrument.
Select one of the following options:

NONE*
Item Not Displayed

PIN
Enter personnel PIN > _

TOUCH
Present personnel touch key

RF ID
Present personnel RF ID card

NEXWATCH
Present personnel NexWatch card
identify the vehicle to the instrument.
Select one of the following options:
Model 1010 Application Pack CB
Programming Manual
Part No.: 4418024 - Rev. 1