Honeywell Enraf 1010 CB Programming Manual page 65

Metering Lines (4)
Meter n
Manual DP
Meter n
Calculate FP
Meter n
Manual FP
6 - 11
If the Pm is regulated, enter the manual value for Dp.
Constraints:

Only available when you use the Weights and Measures switch on
the instrument to enter programming mode.

Available only if commodity type is NGL and LPG(E) and

Regulated PM is selected as YES.
Enter a value in the following range:

Refer to Table 6-5
Table 6-5: MPMS Equilibrium and Compressibility Calculations
Base
Units
Temp
Psig 60 °F
15 °C
kPa
20 °C
Selects whether to calculate the Compressibility Factor or not.
Constraints:

Only available when you use the Weights and Measures switch on
the instrument to enter programming mode.

Available only if commodity type is NGL and LPG(E) and

Regulated PM is selected as NO.
Select one of the following options:

Yes

No*
This prompt allows entry of the manual value for the compressibility
factor (F)
Constraints:

Only available when you use the Weights and Measures switch on
the instrument to enter programming mode
and
• Commodity type is NGL and LPG(E) and Regulated PM is
selected as YES.
Or
• Regulated PM is selected as NO and calculate FP is selected as
NO.
Model 1010 Application Pack CB
Programming Manual
Entry Ranges
Equilibrium Pressure (Pe)
0 to 2200.0
0 to 15168.47
Manual Entry of Dp
0 to 2200.0
0 to 15168.47
Part No.: 4418024 - Rev. 1