Name/Setup Menu - Honeywell Enraf 1010 CB Programming Manual

Additive Lines (6)
Enable Injection No n Enables or disables the injection point.
Injector No n Assigns an injector number (n) to an arm number. If you do not wish to
8 - 3
Once an injection point is selected, the following menu, which allows
configuration of different parameters of the injection point, is displayed.

8.5.1 Name/Setup Menu

Select one of the following options:

Enable

Disable*
assign an additive injector, select NONE. Changing an injector load arm
will erase the arm's recipes.
Constraints: Available only when the injector point is enabled.
Select one of the following options:

NONE to max available arm number (NONE*)
Model 1010 Application Pack CB
Programming Manual
INTERNAL ADDITIVE LINES INTERNAL ADDITIVE LINES
- INJECTION POINT 5 - INJECTION POINT 5
- INJECTION POINT 6 - INJECTION POINT 6
- INJECTION POINT 1 - INJECTION POINT 1
- INJECTION POINT 2 - INJECTION POINT 2
- INJECTION POINT 3 - INJECTION POINT 3
PRESS ENTER TO SELECT PRESS ENTER TO SELECT
INTERNAL ADDITIVE LINES INTERNAL ADDITIVE N INTERNAL ADDITIVE LINES INTERNAL ADDITIVE N
- METER FACTOR - METER FACTOR - METER FACTOR - METER FACTOR
- CON - CON - CON - CON
- NAME/SETUP - NAME/SETUP - NAME/SETUP - NAME/SETUP
- ALARM SETUP - ALARM SETUP - ALARM SETUP - ALARM SETUP
- K FACTOR - K FACTOR - K FACTOR - K FACTOR
PRESS ENTER TO SELECT PRESS ENTER TO SELECT PRESS ENTER TO SELECT PRESS ENTER TO SELECT
61 61
61 61N 61 61N
Part No.: 4418024 - Rev. 1