Honeywell Enraf 1010 CB Programming Manual page 66

Metering Lines (4)
Meter n
Calculate PE
Meter n
Manual PE
Meter n
Density Input
6 - 12
Enter a value in the following range:

Refer Table 6-6
Table 6-6: MPMS Equilibrium and Compressibility Calculations
Units
PSIg
kPa
When pressure correction is selected for commodity group E (NGL and
LPG), the prompt allows selecting whether to calculate the Equilibrium
Pressure or not.
Constraints:

Only available when you use the Weights and Measures switch on
the instrument to enter programming mode.

Available only if commodity type is NGL and LPG (E) and
Regulated Pm is selected as NO.
Select one of the following options:

Yes

No*
If the Pe value is not to be calculated, enter the manual value for the
Equilibrium Pressure (Pe).
Constraints:

Only available when you use the Weights and Measures switch on
the instrument to enter programming mode.

Available only if commodity type is NGL and LPG and Calculate PE
is selected as NO
Enter a value in the following range:

Refer to Table 6-5.
Mass units with volume preset
If the arm is configured for Mass units with volume preset the operator
can setup a density probe.
Selects which density input mode to be used for density measurement.
Constraints:

Only available when you use the Weights and Measures switch on
the instrument to enter programming mode.

Only if mass meter used with volume preset
Select one of the following options:
Model 1010 Application Pack CB
Programming Manual
Base
Entry Ranges
Temp
Compressibility Factor (F)
60 °F 0 to 65.8×10
15 °C
0 to 454.4×10
20 °C
-6
-6
Part No.: 4418024 - Rev. 1