Alarm Setup - Honeywell Enraf 1010 CB Programming Manual

Loading Arms (3)
Slow Start Quantity For Off/On valves, the load is started and the slow flow relay opens.
Arm Full Flow Sets the desired flow rate when full flow is required. Flow is set to full
Blend Tolerance Alarm If enabled, the instrument will trigger the blend tolerance alarm when
Low Percentage The instrument triggers the blend tolerance low alarm if the blend ratio
High Percentage The instrument triggers the blend tolerance high alarm if the blend ratio
5 - 4
Constraints: Only applicable when the arm is configured for ratio
After the flow meter measures the Slow Start Quantity, the high flow
relay opens. For digital valves, the time after which the flow rate is
adjusted from the valve slow flow rate to the valve full flow rate. For
Digital valves, the load is started and the slow flow relay opens. After
the flow meter measures the Slow Start Quantity, the instrument adjusts
the flow rate Valve Slow Flow rate to the Valve Full Flow rate.
Enter a value in the following range:

0 to 9999 (300*)
flow rate after the start time has elapsed, and remains at this flow rate
until the delivered quantity has reached the preset less the pre-stop
quantity.
Constraints:

Only for Valve Type = Digital

Only applicable when the arm is configured for ratio blending.
Enter a value in the following range:

(Slow Flow) to 9999 (2000*)

5.2.5 Alarm Setup

blend percentage is less than low percentage or greater than high
percentage.
Select one of the following options:

ENABLE

DISABLE*
Constraints: Not available for straight loading arm.
is below the LOW PRECENTAGE and the blend tolarance alarm is
enabled.
Enter a value in the following range:

0.10 to 20.00 (1.00*)
deviation is greater than HIGH PRECENTAGE and the blend tolarance
alarm is enabled.
Enter a value in the following range:

0.10 to 20.00 (1.00*)
Model 1010 Application Pack CB
Programming Manual
blending.
Part No.: 4418024 - Rev. 1