Honeywell Enraf 1010 CB Programming Manual page 10

Programming Mode
NOTE:
2 - 2
The factory default for this password is 6789 but it may be changed
under the GENERAL SETUP sub-menu of the SYSTEM menu (see
CHAPTER 4).
If the setup password is lost, record the four to eight digit hexadecimal
number that is displayed at the password prompt (XXXXXXXX), and then
contact a Honeywell supplier, who will be able to convert this number to the
setup password.
If the password entered matches the setup password programmed in
the instrument, the instrument displays the software version number.
V4-000-1010A-CB-VEO03.000-2594 V4-000-1010A-CB-VEO03.000-2594
3. Press any key to show the time and date that the application
software was compiled.
4. Press any key to show the Weights & Measures software version.
5. Press any key to advance the display to show the time and date
that the Weights & Measure (W&M) section of the software was
compiled.
W&M LIB: JUN 2 2009, 12:02:01 W&M LIB: JUN 2 2009, 12:02:01
6. Press any key.
The instrument displays the Main Menu.
MAIN MENU MAIN MENU
6 - ADDITIVE LINES 6 - ADDITIVE LINES
7 - RECIPES 7 - RECIPES
1 - DISPLAY CONTRAST 1 - DISPLAY CONTRAST
1 - DISPLAY CONTRAST 1 - DISPLAY CONTRAST
2 - SYSTEM 2 - SYSTEM
3 - LOADING ARMS 3 - LOADING ARMS
Model 1010 Application Pack CB
Programming Manual
PRESS ANY KEY PRESS ANY KEY
JUN 12 2009, 11:53:36 JUN 12 2009, 11:53:36
PRESS ANY KEY PRESS ANY KEY
W&M VERSION: 8 W&M VERSION: 8
PRESS ANY KEY PRESS ANY KEY
PRESS ANY KEY PRESS ANY KEY
PRESS ENTER TO SELECT PRESS ENTER TO SELECT
Part No.: 4418024 - Rev. 1