Honeywell Enraf 1010 CB Programming Manual page 28

System (2)
Ask Return Qty. If enabled, the instrument prompt asks if there is already product in the
Ask Load Number If enabled, the operator is prompted to enter a load number.
Ask Reference Number The reference number prompt is only available when the instrument is
Simultaneous Arm
Loading
Multiple Loads per Arm If enabled, the operator is prompted whether to load another
Ask Preset quantity If enabled, the operator is prompted to enter a preset value for the load.
4 - 12
target compartment. In stand-alone mode, this quantity is deducted
from the total required to give the preset quantity. The return quantity is
not deducted when in load scheduling mode.
Select one of the following options:

Enable

Disable*
The Ask Load No prompt is disabled when RIT is enabled. Users can
enable the prompt.
Select one of the following options:

Enable*

Disable
in standalone mode. It is used when a TAS would normally handle the
authorisation of the personnel or vehicle. This allows entry of a
reference number when the TAS is unavailable. The reference number
can be reconciled by the TAS at a later stage with the company who
received the product, thus providing correct invoicing.
Select one of the following options:

Enable

Disable*
If enabled, allows more than one arm/product to be loaded at a time. If
disabled only one arm/product may be loaded at a time. This may be
used when top loading of tankers is required.
Constraints: Only if number of arms is greater than 1
Select one of the following options:

Enable*

Disable
compartment at the end of each batch. If disabled, only one batch per
arm per transaction is allowed.
Select one of the following options:

Enable*

Disable
The Ask Preset Quantity prompt is disabled when RIT is enabled. Users
can enable the prompt.
Model 1010 Application Pack CB
Programming Manual
Part No.: 4418024 - Rev. 1