Busy Channel Lockout - Kenwood TK-2170 Series Function Reference

10 BUSY CHANNEL LOCKOUT

10.1 Busy Channel Lockout
This function automatically restricts the transmission so
as not to interfere with other communications.
If a user transmits on a channel while other groups are
using the same channel, the user may interfere with
communications. This function prevents such
interference.
"BUSY" appears on the LCD even if the PTT switch is
pressed while this function is enabled. In this case, the
transceiver emits the Warning Tone and does not
transmit. The transceiver emits the Warning Tone until
the PTT switch is released.
Busy Channel Lockout can be configured for each
channel by using KPG-101D.
conditions to restrict transmissions with Busy Channel
Lockout.
Table 10-1 Conditions to Restrict Transmissions with Busy
Channel Lockout
Busy Channel Lockout
Busy Channel Lockout does not
No
activate.
Disables transmission when
QT/DQT configured for a channel
QT/DQT Tone
does not match the received
QT/DQT.
Disables transmission until Optional
Optional Signaling
Signaling matches.
Disables transmission while the
carrier is being received. However,
Carrier Only the transceiver transmits even if a
carrier is detected while the Monitor
is enabled.
Note:
Busy Channel Lockout is only available in Conventional Group.
Talk Around Busy Channel Lockout is used for Trunking
System. (Refer to 11.2.1 Talk Around Busy Channel Lockout on
page 35.)
Busy Channel Lockout does not activate in Emergency Mode.
The transceiver transmits even if a signal is detected while
Squelch Off and Monitor functions are enabled.
Configuration using KPG-101D
• Configuring the Busy Channel Lockout (Refer to
FPRG 6.4.12 Busy Channel Lockout.)
FUNC (K)/Ver. 1.01
Following are the
Condition
Confidential 33
Contents Index