Kenwood TK-2170 Series Function Reference page 52

14 CONVENTIONAL GROUP
14.1.5 Optional Signaling
Decode Condition
Carrier Decode or QT/DQT Decode can be configured for
Optional Signaling Decode Condition.
Optional Signaling Decode Condition can be configured
by using KPG-101D.
Configuration using KPG-101D
• Configuring the Optional Signaling Decode
Condition (Refer to FPRG 6.2.5 Optional
Signaling Decode Condition.)
14.1.6 Audio Control
Audio Control can be used to configure conditions for the
transceiver to unmute with QT/DQT and Optional
Signaling. (Refer to 16.3 Signaling (Audio Control) on
page 56.)
Audio Control can be configured by using KPG-101D.
This function can be configured for each zone.
Configuration using KPG-101D
• Configuring the Audio Control (Refer to FPRG
6.2.6 Audio Control.)
14.1.7 Time-out Timer (TOT)
Time-out Timer is used to restrict the continuous
transmission time. (Refer to 9 Time-out Timer (TOT) on
page 31.)
The Time-out Timer can be configured by using
KPG-101D.
Configuration using KPG-101D
• Configuring the Time-out Timer (TOT) (Refer to
FPRG 6.2.7 Time-out Timer (TOT).)
14.1.8 TOT Pre-alert
The transceiver emits the TOT Pre-alert to notify a user
that the transmission is going to be terminated by the
Time-out Timer. (Refer to 9.1.2 TOT Pre-alert on page
31.)
The timing to emit the TOT Pre-alert Tone before the TOT
terminates the transmission can be configured by using
KPG-101D.
Configuration using KPG-101D
• Configuring the TOT Pre-alert (Refer to FPRG
6.2.8 TOT Pre-alert.)
40
Index Contents
14.1.9 TOT Rekey Time
The TOT Rekey Time can be used to configure the
duration of time from when the transmission ends by the
Time-out Timer until a transmission is possible again.
(Refer to 9.1.3 TOT Rekey Time on page 31.)
The TOT Rekey Time can be configured by using KPG-
101D.
Configuration using KPG-101D
• Configuring the TOT Rekey Time (Refer to FPRG
6.2.9 TOT Rekey Time.)
14.1.10 TOT Reset Time
The TOT Reset Time is the period to reset the Time-out
Timer. (Refer to 9.1.4 TOT Reset Time on page 31.)
The TOT Reset Time can be configured by using
KPG-101D.
Configuration using KPG-101D
• Configuring the TOT Reset Time (Refer to FPRG
6.2.10 TOT Reset Time.)
14.1.11 Zone Add
Zone Add can be used to add a zone to the scan list by
using KPG-101D.
Configuration using KPG-101D
• Configuring the Zone Add (Refer to FPRG 6.2.11
Zone Add.)
14.1.12 Scan List (TK-3173 only)
Scan List can be configured for each zone in conjunction
with the Scan List Table configuration by using KPG-
101D.
Configuration using KPG-101D
• Configuring the Scan List (Refer to FPRG 6.3.13
Scan List and FPRG 6.3.15 Scan List Table
Window.)
Confidential FUNC (K)/Ver. 1.01