Kenwood TK-2170 Series Function Reference page 86

18 DTMF
Table 18-11 Key Operation
Key
Increments or decrements the entered
Selector
character.
Side 1 Exits from the current mode.
[S] Moves to next item.
Press: Deletes a character.
[A]
Hold: Deletes all characters
[<B]
[C>] Confirms the entered character.
Side 2
[0] (Space)/ 0
[1] 1
[2] A/ B/ C/ 2
[3] D/ E/ F/ 3
[4] G/ H/ I/ 4
[5] J/ K/ L/ 5
[6] M/ N/ O/ 6
[7] P/ Q/ R/ S/ 7
[8] T/ U/ V/ 8
[9] W/ X/ Y/ Z/ 9
[*] Confirms the entered character.
Press: Deletes a character.
[#]
Hold: Deletes all characters
The transceiver exits from the current
PTT switch
mode and transmits.
Transceiver Operation
Configuring and Changing the Autodial
1. Press the Autodial Programming key.
The list number 1 of the Autodial List appears
on the display. No list number appears on the
display if the Autodial List is not configured.
2. Select the Autodial List number to configure.
"BLANK + List number" appears on the display.
Using the PF keys
•
Press the [<B] or [C>] key.
• Using the Selector
Turn the Selector.
*1
If the List Selection Key (Selector) is enabled.
74
Index Contents
Operation
-
-
*1
Confidential
3. Press the [S] or [*] key.
The list number is confirmed.
4. Enter the List name using the Selector or
keypad.
5. Press the [S] key after entering the character.
The Autodial List Name is confirmed.
6. Enter the DTMF code using the Selector or
keypad.
7. Press the [S] key after entering the entire code.
The writing confirmation window appears on
the display.
"STORE" appears on the display if no data is
stored in the memory.
"OVERWRT" appears on the display if data
exists in the memory.
8. Press the [S] or [*] key.
Data is written to the memory and the Autodial
List Selection window appears on the display.
FUNC (K)/Ver. 1.01