Kenwood TK-2170 Series Function Reference page 129

22.1.10 Emergency Mode Type
The transceiver can be configured to emit the received
audio in Emergency Mode.
Man-down Mode Type can be configured in the following
way by using KPG-101D.
Table 22-4 Emergency Mode Type Operation
Emergency Mode Type
The transceiver mutes the received
Silent
audio while in Emergency Mode.
The transceiver emits the received
Audible
audio in Emergency Mode.
Configuration using KPG-101D
• Configuring the Emergency Mode Type (Refer to
FPRG 6.14.10 Emergency Mode Type.)
22.1.11 Emergency-key Delay Time
The duration from when the Emergency key is pressed
to when the transceiver enters Emergency Mode can be
configured. When the Emergency key is pressed and
held for the configured duration, the transceiver enters
Emergency Mode. This delay time prevents Emergency
Mode from being entered unintentionally.
The Emergency-key Delay Time can be configured by
using KPG-101D.
Configuration using KPG-101D
• Configuring the Emergency-key Delay Time
(Refer to FUNC 6.14.11 Emergency-key Delay
Time.)
22.1.12 Emergency Mic Sense
Mic Gain in Emergency Mode can be configured by using
KPG-101D. (Refer to 1.12 Mic Sense on page 6.)
Configuration using KPG-101D
• Configuring the Emergency Mic Sense (Refer to
FPRG 6.14.12 Emergency Mic Sense.)
FUNC (K)/Ver. 1.01
Operation
Confidential
22.1.13 Emergency ACK Code
A user in Emergency status can notice that the
transceiver received a response from the dispatcher
when the transceiver receives the Emergency ACK Code
sent from the dispatcher if DTMF is configured for
Emergency ID.
Two dots located on the lower right of the display appear
when the transceiver receives the Emergency ACK Code
while in Emergency Mode.
Emergency ACK Code can be configured by using KPG-
101D. (Refer to FPRG 6.4.13 Emergency ACK Code.)
Note: Emergency ACK Code cannot be configured if anything
other than "DTMF" is selected from the Emergency ID
dropdown list.
Configuration using KPG-101D
• Configuring the Emergency ACK Code (Refer to
FPRG 6.14.13 Emergency ACK Code.)
22.1.14 Emergency Reset Code
The transceiver exits from Emergency Mode when the
transceiver receives the Emergency Reset Code while
DTMF is configured for Emergency ID.
Emergency Reset Code can be configured by using KPG-
101D. (Refer to FPRG 6.4.14 Emergency Reset Code.)
Note: Emergency Reset Code cannot be configured if anything
other than "DTMF" is selected from the Emergency ID
dropdown list.
Configuration using KPG-101D
• Configuring the Emergency Reset Code (Refer to
FPRG 6.4.14 Emergency Reset Code.)
22.1.15 Emergency Recognition
Emergency Recognition can be used to notify a user that
the transceiver is in Emergency Mode when DTMF is
configured for Emergency ID.
Three dots located on the lower left of the display appear
when the transceiver enters Emergency Mode.
Emergency Recognition can be configured to be enabled
or disabled by using KPG-101D. (Refer to FPRG 6.4.15
Emergency Recognition.)
Note: Emergency Recognition cannot be configured if anything
other than "DTMF" is selected from the Emergency ID
dropdown list.
22 EMERGENCY MODE
Contents Index
117