Kenwood TK-2170 Series Function Reference page 99

When the Status Message is properly sent
to the receiving party:
"COMPLETE" appears on the display.
When the Status Message is not properly
sent to the receiving party:
"NO REPLY" appears on the display.
When the channel is busy and the
transceiver cannot send the Status
Message:
"BUSY" appears on the display.
When canceling the Status Message
transmission:
Press the Side 1 key while "SEND DAT"
appears on the display.
"CANCEL" appears on the display and the
transmission is cancelled.
Sending a Status Message with Manual Dialing
1. Press the Status or Selcall + Status key.
The transceiver enters Status List Selection
Mode.
The transceiver enters Status List Selection
Mode if the [S] or [*] key is pressed after the
Selcall + Status key is pressed and the Selcall
ID is selected.
Selcall on page 82.)
FUNC (K)/Ver. 1.01
(Refer to 20.2.1 Making a
2. Press and hold the [S] or [*] key for 1 second.
The transceiver enters Status Code Entry
Mode.
The last used status appears on the display.
No code appears on the display when the
transceiver enters Status Code Entry Mode for
the first time.
3. Enter the code.
• Using the Selector
Select a code using the Selector.
Press the [C>] key after selecting the code.
*1
• Using the keypad
Enter the code using the [0] to [9] keys.
• Deleting the Entered Code:
Press the [A] or [#] key.
The selected character will be deleted.
Press and hold the [A] or [#] key.
All characters will be deleted.
4. Press the PTT switch or Side 2 key.
The transceiver sends the Status Message.
Confidential
20 FLEETSYNC
*1
If the List Selection Key (Selector) is enabled.
Contents
87
Index