Kenwood TK-2170 Series Function Reference page 103

20.3.8 Target Fleet/ Target ID (Status
Message)
Target Fleet/ Target ID is the target FleetSync ID for
sending the following Status Messages:
• Status Message transmission using the Call 1 or Call 2
key
• Transmission when the transceiver enters
Transmission Mode by pressing the Status key
Target FleetSync ID can be configured by using
KPG-101D. The FleetSync ID of the dispatcher is
normally configured for the Target Fleet/ Target ID
(Status Message).
Configuration using KPG-101D
• Configuring the Target Fleet (Refer to FPRG
6.12.3 Parameter Tab - Target Fleet (Status
Message).)
• Configuring the Target ID (Refer to FPRG 6.12.3
Parameter Tab - Target ID (Status Message).)
20.3.9 Status 80 - 99 (Special)
Status 80 to 99 (reserved status) are used to make the
specified operations. This function prevents a user from
accidentally sending Status 80 to 99.
Configure whether the transceiver sends Status 80 to 99
(Special).
Configuration using KPG-101D
• Configuring the Status 80 - 99 (Special) (Refer to
FPRG 6.12.1 General 1 Tab - Status 80 - 99
(Special).)
FUNC (K)/Ver. 1.01
20.3.10 Emergency Status Response
Emergency Status Response is the transceiver's reaction
to receiving an emergency status message.
"MAN DOWN" appears on the display when the
transceiver receives Status 98. "EMG" appears on the
display when the transceiver receives Status 99.
However, the configured data appears on the display
when the Emergency Status is configured in the Status
List.
The following functions can be configured for Emergency
Status Response by using KPG-101D.
Table 20-11 Emergency Status Response Operation
Emergency Status
Response
None
Alert Tone
Configuration using KPG-101D
• Configuring the Emergency Status Response
(Refer to FPRG 6.12.1 General 1 Tab - Emergency
Status Response.)
Confidential
20 FLEETSYNC
Operation
The transceiver activates as normal.
Alert Tone configured for Emergency
Status sounds when receiving an
Emergency Status. Press any key other
than the Volume Up or Volume Down
key to stop the Alert Tone.
Contents Index
91