Kenwood TK-2170 Series Function Reference page 101

20.3.3 Reserved Status for Status
Messages
Status Message has reserved statuses. Below is a list of
reserved status.
Table 20-8 Reserved Status List
Status Function
Receiving Side
Statuses
Normal Status
10 to 79 intended for
operation.
users
80 Default Status
81 to 87 Undefined
Exits from
Emergency
88 Emergency
Reset Command
Mode.
Horn Alert
89 Activation
Command
The transceiver
sends the ACK.
Remote Stun
Transmission is
Transmit
restricted. "93"
90
Restriction
is configured for
Command
Current Status.
*2
The transceiver
sends the ACK.
Remote Stun Transmission
Transmit and and reception
91 Receive are restricted.
Restriction "94" is
Command configured for
Current Status.
*2
The transceiver
sends the ACK.
Remote Stun Disables Stun.
92
Reset Command "80" is
configured for
Current Status.
Remote Stun
Transmit
93
Restriction
Response
Remote Stun
Transmit and
94 Receive
Restriction
Response
Reserved Status
for Emergency
The transceiver
Mode
sends the ACK.
98: Man-down
95 to 99
Alert/ Horn/
Status
99: Emergency
None
Status other
than Man-down
FUNC (K)/Ver. 1.01
Entry of Status with
Entry Method
Operation at
Manual
Dial Control
Yes
-
-
-
Yes/ No
*1
-
-
*3
*1
Entry of Statuses 80 to 99 can be enabled or disabled by using
KPG-101D when directly entering a status number with Manual
Dialing. (Refer to 20.3.9 Status 80 - 99 (Special) on page 91.)
*2
Stun Status does not change even if a user changes the Status in
Status Mode.
*3
Entry of Statuses 95 to 99 in Emergency Mode can be configured
to be enabled or disabled by using KPG-101D.
Status 80 - 99 (Special) on page 91.)
PC
Emergency
Alert Tone configured for Emergency Status
Response sounds when receiving a reserved Status.
Remote Stun
Remote Stun can be used to disable almost all the
transceiver's functions. Only the following operations
are available when Stun is enabled. The transceiver
recovers from the Stun status when receiving the Stun
Deactivation status message or the DTMF Stun
Deactivation command.
Table 20-9 Operation when Stun Enabled
Status Message
Normal Status
Message
operation
PC Control
Yes
Statuses 90 to 92
These statuses are used to activate or reset Stun.
The statuses are enabled regardless of the Stun
status in the receiving party's transceiver.
Statuses 93 to 94
These statuses are used to respond with the Stun
status of the transceiver when receiving the RSTM
(Request Status).
Confidential
20 FLEETSYNC
(Refer to 20.3.9
Transmit Transmit and
Restriction Receive Restriction
Transmit and
Transmit Restriction
Receive Restriction
The transceiver does The transceiver does
not accept a not accept a
transmission request. transmission request.
The transceiver does The transceiver does
not send received not send received
data. data.
Contents
89
Index