Kenwood TK-2170 Series Function Reference page 85

18.3.12 Selective Call Alert LED
Selective Call Alert LED can be used to make the
Selective Call Alert LED blink when the transceiver
receives a code.
This function allows a user to monitor a call when away
from the transceiver.
Selective Call Alert LED can be configured to be enabled
or disabled by using KPG-101D.
Function on page 82.)
Configuration using KPG-101D
• Configuring the Selective Call Alert LED (Refer to
FPRG 6.10.2 Decode Tab - Selective Call Alert
LED.)
18.3.13 DTMF Number Display
DTMF Number Display allows a user to view a received
DTMF code if the transceiver receives a DTMF code with
at least 3 numeric digits. The received code appears on
the display while the Channel Name or DTMF code
appears on the display.
The display is updated when the transceiver does not
receive another code for more than 1 second after the
transceiver received the DTMF code. Only the first 8
numeric digits can be displayed if the transceiver receives
a code with more than 8 numeric digits.
DTMF Number Display functions only for a channel on
which Off is configured for DTMF signaling and DTMF is
configured for Optional Signaling. The display is not
updated in the following conditions:
• When the transceiver receives the Stun Code or Stun
Deactivation Code.
• When the transceiver is in Emergency Mode.
The previous channel appears on the display if any key is
pressed while the DTMF code appears on the display.
The previous CH/GID appears on the display when the
Auto Reset Timer expires if the display for the Auto Reset
Timer is configured.
DTMF Number Display can be configured to be enabled
or disabled by using KPG-101D.
Note:
DTMF Number Display is only used for viewing the caller's ID.
A user cannot reply to the ID displayed on the display.
Optional Signaling cannot be decoded if DTMF Number Display
is enabled.
Configuration using KPG-101D
• Configuring the DTMF Number Display (Refer to
6.12.2. Decode Tab - DTMF Number Display
(Conventional).)
FUNC (K)/Ver. 1.01
(Refer to 20.2 Selcall
Confidential
18.4 Autodial
The following functions relevant to Autodial can be
configured by using KPG-101D:
• Autodial List
• Autodial Programming
18.4.1 Autodial List
Autodial List can be used to configure the DTMF code
used in Autodial.
Autodial List can be configured by using KPG-101D.
Below is a list of configuration items for Autodial List.
Table 18-10 Autodial List Configuration
Autodial List
A name can be assigned to the DTMF
Name code. A maximum of 8 characters can
be configured for each DTMF code.
The DTMF code to send can be
configured. A maximum of 16
Code
characters can be configured for each
DTMF code.
Configuration using KPG-101D
• Configuring the Name (Refer to FPRG 6.10.3
Autodial List Tab - DTMF Name.)
• Configuring the Code (Refer to FPRG 6.10.3
Autodial List Tab - Code.)
18.4.2 Autodial Programming
Autodial Programming can be used to configure, change
or delete the Autodial List using the PF key.
Name and DTMF code can be changed by pressing the
Autodial Programming key while Autodial Programming
is enabled.
Autodial Programming can be configured to be enabled
or disabled by using KPG-101D.
Note: Keys operate as below if the List name or the DTMF code is
entered.
18 DTMF
Operation
Contents Index
73