Hardware Breakpoint - Renesas R0E521000EPB00 User Manual

R0E521000EPB00 User's Manual

3.4 Hardware Breakpoint

Hardware break is set by event condition such as FETCH or DATA ACCESS, etc. If the breakpoint you set is a hardware
breakpoint, the program stops after executing the instruction at the set breakpoint (after several cycles).
(1) Breakpoint setup dialog box
1) Opening the hardware breakpoint setup dialog box
2) H/W Break Point Setting Window
H/W Break Point Setting Window *
Enable H/W Break
Combination
Reset
Save...
REJ10J0844-0400 Rev.4.00 October 16, 2007
Page 55 of 88
PID
Detail...
Detail... Enable
Load... Set Close
3. Usage (Emulator Debugger)
Hardware Breakpoint
Clicking this button opens the hardware breakpoint setup dialog
box.
Or you can select the "H/W break point (H)" of "Break (B)" from
"View (V)" menu for the same effect.
H/W Break Point Setting Window
Select the "Enable H/W Break" check box, and this break function
will be enabled, allowing you to set hardware breakpoints.
Setting Break Event
Click the event line at which you want set a break event.
Setting Pass Count
For each event, a pass count (number of passing) is specifiable (1--
255). When "AND" (same time) is specified for Combination, you
can not specify the pass count (fixed to one).