Renesas R0E521000EPB00 User Manual page 59

R0E521000EPB00 User's Manual
(4) Setting the combinatorial event condition for the hardware breakpoint
1) Window for setting the combinatorial event condition
H/W Break Point Setting Window *
Enable H/W Break
Combination
Reset Save...
REJ10J0844-0400 Rev.4.00 October 16, 2007
Page 59 of 88
PID
Detail... Enable
Detail...
Load... Set Close
3. Usage (Emulator Debugger)
Setting the combinatorial event condition
There are following four conditions that you can choose for the
combinatorial events.
- AND
The program breaks when all of the specified events occur.
- AND (Same Time)
The program breaks when the specified events occur at the
same time.
- OR
The program breaks when one of the specified events occurs.
- STATE TRANSITION
The program breaks when the state transition diagram goes into
the break state.
For each event, a pass count (number of passing) is specifiable (1--
255). When "AND" (same time) is specified for Combination, you
can not specify the pass count (fixed to one).
When you have finished setting the combinatorial event condition,
click the "Set" button.