Hardware Breakpoint - Renesas R0E521000CPE00 User Manual

R0E521000CPE00 User's Manual

3.4 Hardware Breakpoint

Hardware break is set by event condition such as FETCH or DATA ACCESS, etc. If the breakpoint you set is a hardware
breakpoint, the program stops after executing the instruction at the set breakpoint (after several cycles).
(1) Breakpoint setup dialog box
1) Opening the hardware breakpoint setup dialog box
2) H/W Break Point Setting Window
H/W Break Point Setting Window*
Enable H/W Break
Combination
Detail...
Reset Save...
REJ10J0845-0600 Rev.6.00 Aug. 20, 2009
Page 57 of 92
PID
Enable Detail...
Load... Set
Close
3. Usage (How to Use the Emulator Debugger)
Hardware Breakpoint
Clicking this button opens the hardware breakpoint setup dialog
box.
Or you can select the "H/W break point (H)" of "Break (B)" from
"View (V)" menu for the same effect.
H/W Break Point Setting Window
Select the "Enable H/W Break" check box, and this break function
will be enabled, allowing you to set hardware breakpoints.
Setting Break Event
Click the event line at which you want set a break event.
Setting Path Count
For each event, a pass count (number of passing) is specifiable (1--
255). When "AND" (same time) is specified for Combination, you
can not specify the pass count (fixed to one).