Connecting To A 20-Pin 0.65Mm Pitch Lssop Foot Pattern - Renesas R0E521000EPB00 User Manual

R0E521000EPB00 User's Manual

2.9.2 Connecting to a 20-pin 0.65mm pitch LSSOP Foot Pattern

Figure 2.9 shows how to connect the emulation probe to a 20-pin 0.65mm pitch LSSOP foot pattern on the user system with
the R0E521174CSJ00 (included with the R0E521174EPB00) and here following is its procedure.
For details on the R0E521174CSJ00, refer to the user's manual.
(1) Mount the NSPACK20BG included with the R0E521174CSJ00 to the user system.
(2) Attach the YSPACK20BG included with the R0E521174CSJ00 to the NSPACK20BG, and fix them with the YS-GUIDE's.
(3) Attach the J3 and J4 of the R0E521000EPB00 to the R0E521174CSJ00.
(4) Attach the R0E521174CSJ00 to the YSPACK20BG.
Figure 2.9 Connecting to a 20-pin 0.65mm pitch LSSOP foot pattern
Note on Connecting to the User System:
Take care not to attach a converter board in a wrong direction. It may cause a fatal damage to the emulator and
user system.
Notes on Connectors of the Converter Board:
The small connectors of the R0E521000EPB00 and R0E521174CSJ00 are guaranteed for only 50
insertion/removal iterations.
Between the R0E521174CSJ00 and the YSPACK20BG are guaranteed for only 100 insertion/removal iterations
REJ10J0844-0400 Rev.4.00 October 16, 2007
Page 31 of 88
R0E521000EPB00
(3)
YS-GUIDE (x2) *
YSPACK20BG *
NSPACK20BG *
●: No. 1 pin
*: These items are included with the R 0E521174CSJ00 package.
CAUTION
IMPORTANT
R0E521174CSJ00
On-board evaluation
(4)
HQPACK20BG
(not included)
FLASH
version MCU
(2)
(1)
20-pin 0.65mm pitch LSSOP
(PLSP0020JB-A) foot pattern
2. Setup