Connecting To A 20-Pin 1.778Mm Pitch Sdip Foot Pattern - Renesas R0E521000EPB00 User Manual

R0E521000EPB00 User's Manual

2.9.3 Connecting to a 20-pin 1.778mm pitch SDIP Foot Pattern

Figure 2.10 shows how to connect the emulation probe to a 20-pin 1.778mm pitch SDIP foot pattern on the user system with
the R0E521174CDB00 (included with the R0E521174EPB10) and here following is its procedure.
For details on the R0E521174CDB00, refer to the user's manual.
(1) Mount the two pieces of PM-6-10P (10-conducter) included with the R0E521174CDB00 to the user system.
(2) Attach the J3 and J4 of the R0E521000EPB00 to the R0E521174CDB00.
(3) Attach the R0E521174CDB00 to the PM-6-10P.
Figure 2.10 Connecting to a 20-pin 1.778mm pitch SDIP foot pattern
Note on Connecting to the User System:
Take care not to attach a converter board in a wrong direction. It may cause a fatal damage to the emulator and
user system.
Notes on Connectors of the Converter Board:
The small connectors of the R0E521000EPB00 and R0E521174CDB00 are guaranteed for only 50
insertion/removal iterations.
Between the R0E521174CDB00 and the PM-6-10P are guaranteed for only 100 insertion/removal iterations
REJ10J0844-0400 Rev.4.00 October 16, 2007
Page 32 of 88
R0E521000EPB00
(2)
(3)
ＰM-6-10P *
(1)
●: No. 1 pin
*: These items are included with the R 0E521174CＤＢ10 package.
CAUTION
IMPORTANT
R0E521174CDB00
On-board evaluation
FLASH
version MCU
20-pin 1.778mm pitch SDIP
(PRDP0020BA-A) foot pattern
2. Setup