R0E521000EPB00 User's Manual
2.8.2 If an Error is Detected in the Self-check
If the self-check does not result normally (ERROR 1 to ERROR 4 in Figure 2.6), check the following.
(1) Recheck the connection of the emulation probe and PC7501.
(2) Redownload the proper firmware.
Note on the Self-check:
If the self-check does not result normally (excluding user system errors), the emulation probe may be damaged.
Then contact your local distributor.
REJ10J0844-0400 Rev.4.00 October 16, 2007
Page 28 of 88
IMPORTANT
2. Setup