Table of Contents
Advertisement
R0E521000EPB00 User's Manual
2) Specifying the communication interface (LPT communication)
3) Specifying the communication interface (LAN communication)
4) Specifying the communication interface (USB communication)
REJ10J0844-0400 Rev.4.00 October 16, 2007
Page 46 of 88
Specifying
the
communication
communication)
- For selecting the LPT communication, click the radio button "LPT" of the
MCU tab.
- For the Type area, specify the LPT interface communication mode to be
used. If this is the first time you are using the LPT communication,
select "AUTO."
- Specify the I/O address of the parallel port at the I/O address area. For
BIOS setup, the following addresses are available.
- 378h
- 278h
Specifying
the
communication
communication)
- For selecting the LAN communication, click the radio button "LAN" of
the MCU tab.
- Specify the IP address of the emulator at the IP address area. Specify the
IP address by one byte of decimal number separating each four bytes with
a period.
- Specify the port number at the Port area.
[Supplementary explanation]
When you are using LAN communication for the first time, connect to the
emulator through other than LAN communication interface and set the IP
address, or use the SETIP utility included with your product to set the IP
address.
For details about the SETIP utility, refer to the on-line manual of your
emulator debugger.
Specifying
the
communication
communication)
- For selecting the USB communication, click the radio button "USB" of the
MCU tab
- The emulators connected by USB cable are shown at Serial No. area.
Select the serial No. of the emulator you are going to connect.
[Supplementary explanation]
When you are using USB communication for the first time, you must install
the USB driver first.
The USB devices are detected when you turn on the power for the emulator,
and a wizard for installing the corresponding device driver will automatically
be started. Follow the instructions of the wizard to complete installation.
3. Usage (Emulator Debugger)
interface
(LPT
interface
(LAN
interface
(USB
Advertisement
Table of Contents
