Renesas R0E521000EPB00 User Manual page 53

R0E521000EPB00 User's Manual
(2) Setting software breakpoints
3) Setting and executing software breakpoint
4) Completing execution with software break
REJ10J0844-0400 Rev.4.00 October 16, 2007
Page 53 of 88
3. Usage (Emulator Debugger)
Program execution with software breakpoint
- A software breakpoint can be set or cleared by double-clicking
the software breakpoint display area in the editor (source)
window (A red circle is displayed at the setting line).
- Click the execution button.
Or you can select "Go" from "Debug" menu for the same effect.
The cursor stops in the position where the software break was set up.
The statement in which the software break was set up is not
executed.
If the program is started to run from a PC position at which a
software breakpoint is set, instructions at that PC position are
stepped over automatically, and the program is executed from the
next instruction on.