Specifications - Renesas R0E521000EPB00 User Manual

R0E521000EPB00 User's Manual

1.4 Specifications

Tables 1.5 and Table 1.6 list the specifications of the R0E521000EPB00.
Table 1.5 R0E521000EPB00 specifications (1)
Applicable MCUs
Maximum ROM/RAM capacity
Usable mode
Maximum operating frequency
Applicable power supply
Basic debugging functions
Real-time trace function
Real-time RAM monitor function - 4,096 bytes (256 bytes x16)
Hardware break function
Execution time measurement
function
C0 coverage
External trigger input/event
*2
output
Host machine interface
Power supply to emulator
*1: If using this product when the voltage is less than 2.7V, the JP1 of the R0E521000EPBM0 should be set to EXT.
For details, refer to "2.10.2 Setting the POWER Selection Jumper" (page 39).
*2: When the POWER selection jumper is switched to the EXT side, the upper limit of the external trigger input level (VI) is
3.6 [V]. Similarly, the upper limit of the event output level (Vo) is 3.3 [V].
*3: Can be connected to the USB2.0 port of the host machine.
With the USB interface of this product, not all hardware (such as host machine, USB devices, USB hub) combination will
work and guaranteed.
REJ10J0844-0400 Rev.4.00 October 16, 2007
Page 18 of 88
R8C/Tiny Series MCUs
ROM capacity: 112KB (04000h to 1FFFFh) + 4KB (02000h to 02FFFh)
RAM capacity: 8KB (00300h to 012FFh, 03000h to 03FFFh)
Single-chip mode
20MHz at 3.0--5.5V
10MHz at 2.7--5.5V
5MHz at 2.2--5.5V
User system connected
User system not connected
- Download
- Software break (max. 64 points)
- Program execution/stop (allows free-run execution supporting software breaks)
- Memory reference/setting (reference/setting C-variables, run-time execution)
- Register reference/setting
- Disassemble display
- C-level debugging, etc.
- 256K-cycle bus information recordable (Bus, external trigger, time stamp)
- 5 trace modes supported (Break/Before/About/After/Full)
- Can be recorded ON/OFF by events
- Data/last access result
8 points (Execution address, bus detection, interrupt, external trigger signal)
Time between program start and stop
Maximum/minimum/average execution time and pass count of specified four zones.
Count clock: Equal to MCU Clock or 16MHz
8,192KB (256KB x 32 blocks)
External trigger input (MCU-dependent-voltage CMOS level x8) or event output (break
x1, event x7)
- LPT parallel (ECP, EEP, Byte/compatibility and Nibble/compatibility modes)
- USB (USB 1.1, full-speed)
- LAN (10BASE-T)
Supplied from included AC adapter (power supply voltage: 100--240V, 50/60Hz)
*1
2.2--5.5V
(depends on the Power selection jumper)
5.0V (supplied from the emulator)
*3
1. Outline