Hardware Breakpoint Setting Window - Renesas M34286T2-CPE User Manual

M34286T2-CPE User's Manual

3.3 Hardware Breakpoint Setting Window

(1) Breakpoint setup dialog box
1) Opening the hardware breakpoint setup dialog box
2) Hardware Break Point Setting Window in initial state
3) Address event setting dialog box
R20UT0214EJ0200 Rev.2.00
Sep 16, 2010
3. Usage (How to Use the Emulator Debugger)
Hardware Break Point
Clicking this button opens the hardware
breakpoint setup dialog box.
Hardware breakpoint setup dialog box
You can use a combination of address event (A1
or A2) and T (external trigger event) as a
hardware break event.
Setting an address event
Click A1 or A2 to select the address event you
want to set.
Setting an external trigger event
You can set edges or pass counts of external
trigger event.
High: Positive edge
Low: Negative edge
Setting an address event
Here, you can select one of three conditions.
Point: At specified address
Range In: In specified address range
Range Out: Outside specified address range
You also can set a pass count.
Page 45 of 70