Connecting To A 48-Pin 0.5Mm Pitch Lqfp Foot Pattern - Renesas R0E521000EPB00 User Manual

R0E521000EPB00 User's Manual

2.9.4 Connecting to a 48-pin 0.5mm pitch LQFP Foot Pattern

Figure 2.11 shows how to connect the emulation probe to a 48-pin 0.5mm pitch LQFP foot pattern on the user system with the
R0E521237CFK00 (included with the R0E521237EPB00) and here following is its procedure.
For details on the R0E521237CFK00, refer to the user's manual.
(1) Mount the NQPACK048SD included with the R0E521237CFK00 to the user system.
(2) Attach the YQPACK048SD included with the R0E521237CFK00 to the NQPACK048SD, and fix them with the YQ-
GUIDE's.
(3) Attach the J3 and J4 of the R0E521000EPB00 to the R0E521237CFK00.
(4) Attach the R0E521237CFK00 to the YQPACK048SD
(3)
● : No . 1 pin
*: These items are included with the R
Figure 2.11 Connecting to a 48-pin 0.5mm pitch LQFP foot pattern
Note on Connecting to the User System:
Take care not to attach a converter board in a wrong direction. It may cause a fatal damage to the emulator and
user system.
Notes on Connectors of the Converter Board:
The small connectors of the R0E521000EPB00 and R0E521237CFK00 are guaranteed for only 50
insertion/removal iterations.
Between R0E521237CFK00 and the YQPACK048SD are guaranteed for only 100 insertion/removal iterations
REJ10J0844-0400 Rev.4.00 October 16, 2007
Page 33 of 88
R0E521000 EPB 00
(4)
YQ-GUIDE (x4) *4
YQPACK 048 SD *4
(2)
NQPACK 048SD *4
(1)
CAUTION
IMPORTANT
R0E521237 CFK 00
On-board evaluation
HQPACK 048 SD
(not included )
FLASH version
MCU
48-pin 0.5mm pitch LQFP
(PLQP 0048 KB-A) foot pattern
0E521237 CFK 00 package .
2. Setup