Setup; Flowchart Of Starting Up The Emulator - Renesas R0E521000EPB00 User Manual

R0E521000EPB00 User's Manual

2. Setup

This chapter describes the preparation for using this product, the procedure for starting up the emulator and how to change
settings.

2.1 Flowchart of Starting Up the Emulator

The procedure for starting up the emulator is shown in Figure 2.1. For details, refer to each section hereafter. And, when the
emulator does not start up normally, refer to "5. Troubleshooting" (page 80).
Check the package components.
▼
User registration
▼
Install the M16C R8C PC7501 Emulator
Debugger
▼
Connect the host machine.
▼
Connect the PC7501.
▼
Connect the power supply for the emulator.
▼
Connect the power supply for the emulator
and change the settings.
▼
Turning on the power supply.
▼
Check the LED display of the emulator.
▼
Start up the emulator debugger from the
High-performance Embedded Workshop.
▼
Set the operating environment
of the emulator debugger.
▼
Debug a program with various functions of
the emulator debugger
Figure 2.1 Flowchart of starting up the emulator
REJ10J0844-0400 Rev.4.00 October 16, 2007
Page 20 of 88
Refer to "1.1 Package Components" (page 13).
Refer to "User Registration" (page 11).
Install the M16C R8C PC7501 Emulator Debugger.
Connect the PC7501 to the host machine with the LPT parallel
interface cable, USB interface cable or LAN interface cable.
Set the interface selection switch on the rear panel of the PC7501 to
the using interface.
Connect the R0E521000EPB00 to the M3T-FLX160-EPB at the tip
of the PC7501.
Connect a power supply for the emulator.
Connect the user system as occasion demands. Set the power supply
or clock, etc., according to conditions of use.
Turn ON the power to the emulator and the user system as
simultaneously as possible.
Check that POWER, and SAFE of system status LED, and POWER,
CLOCK, and RESET of target status LED are lighting. When the
user system is not connected, the POWER LED does not light up.
Start up the High-performance Embedded Workshop, and the
emulator debugger.
Set the INIT dialog box and MCU Setting dialog box of the
emulator debugger.
For how to use the High-performance Embedded Workshop and the
emulator debugger, refer to each online manual.
2. Setup