Connecting To A 42-Pin 0.8-Mm-Pitch Foot Pattern - Renesas M30290T2-CPE User Manual

M30290T2-CPE User's Manual

2.8.1 Connecting to a 42-pin 0.8-mm-pitch Foot Pattern

Here following is a procedure of connecting to a 42-pin 0.8-mm-pitch foot pattern on the user system using the M30263T-
42SSB (included with the M30263T2-CPE-FP). For details on the M30263T-42SSB, refer to its user's manual.
(1) Mount the socket included with the M30263T-42SSB to the user system.
(2) Attach the M3T-SSOP42B-450 included with the M30263T-42SSB and the socket frame to the socket.
(3) Attach the J1 and J2 of the M30290T-PTCB to the J3 and J4 of the M30290T2-CPE.
(4) Attach the M30263T-42SSB to the M3T-SSOP42B-450.
Figure 2.12 Connecting to a 42-pin 0.8-mm-pitch foot pattern
Notes on Connecting the User System:
Take care not to attach a converter board in a wrong direction. It may cause a fatal damage to the emulator and
user system.
The connectors of the M30290T2-CPE and M30290T-PTCB are guaranteed for only 50 insertion/removal
iterations.
REJ10J0494-0200 Rev.2.00 July 16, 2005
M30290T-PTCB
(3)
Socket frame *
M3T-SSOP42B-450 *
Socket *
●: No. 1 pin
*: These products are included with the M30263T-42SSB package.
M30290T2-CPE
M30263T-42SSB
(4)
(2)
(1)
42-pin 0.8-mm-pitch
(42P2R-E) foot pattern
CAUTION
Socket frame *
MCU with on-chip
flash memory etc.
2. Setup
Page 31 of 86