Connecting To An 80-Pin 0.65-Mm-Pitch Foot Pattern - Renesas M3062PT-EPB User Manual

3.6.1 Connecting to an 80-pin 0.65-mm-pitch Foot Pattern

Here following is a procedure of connecting to an 80-pin 0.65-mm-pitch foot pattern on the target
system using the M3062PT-80FPB (not included). For details on the M3062PT-80FPB (not
included), refer to its user's manual.
Figure 3.12 Connecting to an 80-pin 0.65-mm-pitch foot pattern
Notes on Connecting the Target System:
(1) Attach the NQPACK080SB included with the M3062PT-80FPB to the target system.
(2) Attach the YQPACK080SB included with the M3062PT-80FPB to the NQPACK080SB and
secure it with the YQ-GUIDE's.
(3) Attach the CN2 side of the M3062PT-80FPB to the J4 side of the M3062PT-EPB.
(4) Attach the M3062PT-80FPB to the YQPACK080SB.
These corners are not round.
* Available in one package
• Take care not to attach a converter board in a wrong direction. It may cause a fatal
damage to the emulator and targets system.
• The connectors of the M3062PT-80FPB are guaranteed for only 50 insertion/
removal iterations.
(3)
(4)
*
YQPACK080SB
(3)
NQPACK080SB
(2)
(1)
No. 1 pin
CAUTION
( 35 / 80 )
M3T-FLX100-EPB
M3062PT-EPB
CN2 side
M3062PT-80FPB (not included)
Evaluation with
actual MCU
HQPACK080SB
YQ-GUIDE (x4)
(not included)
MCU with flash
ROM etc.
80-pin 0.65-mm-pitch
(80P6S-A) foot pattern
Target system