Connecting To A 85-Pin 0.65Mm Pitch Foot Pattern - Renesas M3028BT-EPB User Manual

M3028BT-EPB User's Manual

2.9.5 Connecting to a 85-pin 0.65mm pitch Foot Pattern

Here following is a procedure of connecting to an 85-pin 0.65mm pitch foot pattern on the user system with the M30280T-
85LGF (included with the M3028BT-EPB-5), and here following is its procedure. For details on the M30280T-85LGF, refer to
its user's manual.
(1) Attach the CSSOCKET085B1007RE01 included with the M30280T-85LGF to the user system.
(2) Attach the J1 and J2 of the M30290T-PTCB to the J3 and J4 of the M3028BT-EPB.
(3) Attach the M30280T-85LGF to the CSSOCKET085B1007RE01.
Connecting tools
(2)
M30290T-PTCB
These corners are not round.
●: A1 pin
*: This product is included with the M30280T-85LGF package.
Figure 2.12 Connecting to an 85-pin 0.65mm pitch foot pattern
Note on Connecting the User System:
Take care not to attach the converter board in a wrong direction. It may cause a fatal damage to the emulator
and user system.
Notes on Connectors of the Converter Board:
The connectors of the M3028BT-EPB and M30290T-PTCB are guaranteed for only 50 insertion/removal
iterations.
The connectors of the M30280T-85LGF and CSSOCKET085B1007RE01 are guaranteed for only 100
insertion/removal iterations.
REJ10J1459-0200 Rev.2.00 Sep 16, 2006
M3028BT-EPB
M30280T-85LGF
(3)
CSSOCKET085B1007RE01
(*)
85-pin 0.65mm pitch
(PTLG0085JB-A) foot pattern
(1)
No. A1 pin
User system
CAUTION
IMPORTANT
On-board evaluation with actual MCUs
Top cover (＊)
Spacer (＊)
MCU
LSPACK085B1007RE01(＊)
＊: These three products are available in one package.
2. Setup
LSPACK
(not included)
Page 35 of 86