Connecting To A 100-Pin 0.5Mm Pitch Foot Pattern (Part 1) - Renesas R0E3308B0EPB00 User Manual

R0E3308B0EPB00 User's Manual

2.9.1 Connecting to a 100-pin 0.5mm pitch Foot Pattern (Part 1)

Figure 2.8 shows how to connect the emulation probe to a 100-pin 0.5mm pitch foot pattern on the user system with
M30800T-PTC (not included) and M3T-100LCC-QSD (not included), and here following is its procedure. For details on the
M30800T-PTC and M3T-100LCC-QSD, refer to each user's manual.
(1) Attach the M3T-100LCC-QSD to the user system.
(2) Attach the M30800T-PTC to the R0E3308B0EPB00.
(3) Attach the M30800T-PTC to the M3T-100LCC-QSD.
Figure 2.8 Connecting to a 100-pin 0.5mm pitch foot pattern (1/3)
Notes on Connecting the User System:
• Take care not to attach the converter board in a wrong direction. It may cause a fatal damage to the emulator
and user system.
• The small connectors of the R0E3308B0EPB00 and M30800T-PTC are guaranteed for only 50
insertion/removal iterations.
R20UT0210EJ0200 Rev.2.00
Sep 16, 2010
R0E3308B0EPB00
(2)
(3)
(1)
No. 1 pin
CAUTION
M3T-FLX160-EPB
CN2 side
M30800T-PTC
(not included)
M3T-100LCC-QSD
(not included)
100-pin 0.5mm pitch
(100P6Q) foot pattern
User system
2. Setup
Page 31 of 98