Connecting To A 64-Pin 0.8Mm Pitch Foot Pattern - Renesas R0E436640CPE00 User Manual

R0E436640CPE00 User's Manual

2.8.1 Connecting to a 64-pin 0.8mm pitch Foot Pattern

Here following is a procedure of connecting to a 64-pin 0.8mm pitch foot pattern on the user system using the
R0E436640CFG20. For details on the R0E436640CFG20, refer to its user's manual.
(1) Mount the IC149-064-008-B5 included with the R0E436640CFG20 to the user system.
(2) Attach the R0E436640CFG20 to the J3 and J4 of the R0E436640CPE00.
(3) Attach the R0E436640CFG20 to the IC149-064-008-B5, and secure it with the screws (M2x12mm).
R0E436640CIF00
Figure 2.12 Connecting to a 64-pin 0.8mm pitch foot pattern
Notes on Connecting the User System:
Take care not to attach a converter board in a wrong direction. It may cause a fatal damage to the emulator and
user system.
The connectors of the R0E436640CPE00 and R0E436640CFG20 are guaranteed for only 50 insertion/removal
iterations.
REJ10J0918-0300 Rev.3.00 February 15, 2007
R0E436640CPE00
Flat washer *
(2)
Flat washer *
IC149-064-008-B5 *
●: No. 1 pin
*: These items are included with the R0E436640CFG20 package.
CAUTION
Screw (M2×12mm) *
R0E436640CFG20
On-board evaluation
Screw (M2×8mm) *
Upper cover*
(3)
MCU with on-chip
flash memory etc.
(1)
64-pin 0.8mm pitch
(PRQP0064GB-A) foot pattern
2. Setup
Page 32 of 102