Connecting To An 85-Pin 0.65Mm Pitch Foot Pattern - Renesas M3028BT2-CPE User Manual

M3028BT2-CPE User's Manual

2.8.5 Connecting to an 85-pin 0.65mm pitch Foot Pattern

Here following is a procedure of connecting to an 85-pin 0.65mm pitch foot pattern on the user system using the M30280T-
85LGF (included with the M3028BT2-CPE-5). For details on the M30280T-85LGF, refer to its user's manual.
(1) Mount the CSSOCKET085B1007RE01 included with the M30280T-85LGF to the user system.
(2) Attach the J1 and J2 of the M30290T-PTCB to the J3 and J4 of the M3028BT2-CPE.
(3) Attach the M30280T-85LGF to the CSSOCKET085B1007RE01.
Connecting tools
(2)
M30290T-PTCB
These corners are not round.
● : No. A1 pin
*: This product is included with the M30280T-85LGF package.
Figure 2.16 Connecting to an 85-pin 0.65mm pitch foot pattern
Notes on Connecting the User System:
Take care not to attach a converter board in a wrong direction. It may cause a fatal damage to the emulator and
user system.
Note on Connectors of the Converter board:
The connectors of the M3028BT2-CPE and M30290T-PTCB are guaranteed for only 50 insertion/removal
iterations.
REJ10J1457-0300 Rev.3.00 July 22, 2009
M3028BT2-CPE
M30280T-85LGF
(3)
CSSOCKET085B1007RE01
(*)
85-pin 0.65mm pitch
(PTLG0085JB-A) foot pattern
(1)
No. A1 pin
User system
CAUTION
IMPORTANT
On-board evaluation with actual MCUs.
Top cover ( ＊ )
Spacer ( ＊ )
MCU
LSPACK085B1007RE01( ＊ )
＊ : These three products are available in one package.
2. Setup
LSPACK
(not included)
Page 36 of 90