Connection With Other Peripherals (C Controller Module, Etc.) - Mitsubishi Electric MELSEC Q Series User Manual

7.6.6

Connection with other peripherals (C Controller module, etc.)

The C Controller module can be connected with other C Controller modules and/or various network peripherals in the
device (internal microcomputers, etc.) by using the following methods:
• Connection via USB connector
• Connection via the Ethernet port
• Connection with a general-purpose analog RGB display
• Connection via the RS-232 connector
• Connection via network modules
• MELSECNET/H, CMELSECNET/10 connection (PLC-to-PLC network)
• CC-Link IE Controller Network connection
• CC-Link IE Field Network connection
• CC-Link connection
(1) Connection via USB connector
Use the USB connector for connection.
*1 : Use USB2 for Q24DHCCPU-V/-VG/-LS and Q26DHCCPU-LS.
For specifications and wiring of the USB cable, refer to the following.
Page 125, Section 8.7.1
(2) Connection via the Ethernet port
Use the user Ethernet port (CH1 and CH2)/built-in Ethernet port (CH1 and CH2) for connection.
For wiring of the Ethernet cable, refer to the following.
Page 127, Section 8.7.2
114
Q24DHC-V
For "-LS", consult with the
partner (operating system vendor).
*1
Q24DHCCPU-V/-VG/-LS
Q26DHCCPU-LS
For "-LS", consult with the
partner (operating system vendor).
Q24DHCCPU-V/-VG/-LS
Q26DHCCPU-LS
Q24DHC-VG Q24DHC-LS
Note7.1
Q12DCCPU-V
Q12DCCPU-V
Q26DHC-LS Q12DC-V