Installation Procedure For Partner Operating System - Mitsubishi Electric MELSEC Q Series User Manual
Hide thumbs
Also See for MELSEC Q Series:
- User manual (834 pages) ,
- Reference manual (674 pages) ,
- Programming manual (624 pages)
Table of Contents
Advertisement
5.3.1
Installation procedure for partner operating system
The following explains the installation procedure for partner operating system.
Check field
Prepare the installation media
Refer to the manual of the partner operating system, or consult the
partner (operating system vendor).
Connect USB external laptop CD/DVD drive
Connect the USB external laptop CD/DVD drive.
Insert installation media
Insert the installation media in the external drive.
Turn on the power of system
After checking the following status, power ON while pressing the "U
EVENT" switch on C Controller module.
Power supply wiring
Power supply voltage
Installation of partner operating system
Install the partner operating system by following the procedure.
Disconnect USB external laptop CD/DVD drive.
Remove the installation media from the external drive, then disconnect
the external drive.
*1 :
The self-powered drive is required.
When using a keyboard/mouse, connect it via USB hub.
*2 :
Press the EVENT switch until POWER LED of the power module turns ON.
All the display LEDs of the module are turned OFF (because the status of the system CPU is reset).
Start
*1
*2
Operation
CHAPTER 5 PREPARATORY PROCEDURE
5
59
Advertisement
Table of Contents
Troubleshooting
