Mitsubishi Electric MELSEC Q Series User Manual page 125

(2) Uninstallation procedure
EJECT button
2) Press the
EJECT button.
CompactFlash card
● During access to a CompactFlash card, do not perform the following operations:
• Unmounting CompactFlash memory card
• Removing CompactFlash memory card
● You may also unmount the CompactFlash card from the user program by using the CCPU_UnmountMemoryCard.
CHAPTER 8 INSTALLATION AND WIRING
1.
Pull the section labeled as "PULL" on the front
cover to open the cover.
2.
Move the RESET/SELECT switch to the SELECT
position.
Do not release the switch while pulling it down.
3.
Check that the CF CARD LED start flashing.
Keep the switch at the SELECT side while flashing the
LED.
4.
Check that the CF CARD LED goes off.
5.
Move the RESET/SELECT switch back to the center.
6.
Press the EJECT button to remove the
CompactFlash card.
While no CompactFlash card is used, a dummy
CompactFlash card must be used.
7.
Close the C Controller module front cover until it
clicks.
8
123