Error Time Output Mode Setting - Mitsubishi Electric MELSEC Q Series User Manual

(b) Operations in case where writing operation to output (Y) is set in the data refresh
settings
Regardless of the parameter "Output mode at STOP to RUN" (Previous State/Recalculate), the output (Y) is
refreshed by the data refresh right after the status is changed from STOP to RUN.
• When "Previous State" is selected
Output (Y)
• When "Recalculate" is selected
Output (Y)
To maintain the state where output (Y) is cleared (OFF), clear the data refresh memory by the user
program when the status changes from RUN to STOP.
11.1.6

Error time output mode setting

This setting determines whether to clear or hold the outputs to the following modules when a stop error occurs in the C
Controller module.
• Output modules
• I/O combined modules
• Intelligent function modules
• Interrupt modules
(1) Setting method
For this setting, use the following functions in Setting/monitoring tools for the C Controller module.
•
Project view  "Parameter"  "CCPU Parameter"  <<I/O assignment settings>>
 "Detailed Settings"  "Error Time Output Mode"
(2) Precautions
The error time output mode setting takes effect when:
• The C Controller system is powered on.
• The C Controller module is reset.
152
Refresh Refresh
Output by data refresh writing operation right after transition from STOP to RUN status
Refresh Refresh
Output by data refresh writing operation right after transition from STOP to RUN status
Refresh Refresh
Refresh Refresh
Q24DHC-V Q24DHC-VG Q24DHC-LS Q26DHC-LS Q12DC-V