Chapter 4 Software Packages - Mitsubishi Electric MELSEC Q Series User Manual

CHAPTER 4
This chapter describes each software package associated with the C Controller module.
The following software packages can be used for the C Controller module.
Software
Setting/monitoring tools for the C Controller
*1
module
(SW4PVC-CCPU-E)
SW1DND-CWWLQ24-E,
SW1DND-CWWLQ24-EZ
CW Workbench
SW1DND-CWWLQ12-E,
SW1DND-CWWLQ12-EZ
Wind River Workbench
GX Works2
(SW1DNC-GTWK3-J)
GT Designer3
(SW1DNC-GTWK3-E)
MX Component
*1 : Cannot be connected to Q12DCCPU-V (Basic mode).
*2 : For Q24DHCCPU-V with a serial number whose first five digits are "15042" or higher, use Setting/monitoring tools for
the C Controller module Version 4.02C or later.
● For Setting/monitoring tools for the C Controller module, refer to the following.
 Setting/Monitoring Tools for the C Controller Module Version 4 Operating Manual
● For CW Workbench, refer to the following.
CW Workbench Operating Manual
● To create a user program for the C Controller module, CW Workbench or Wind River Workbench 3.2 are necessary. In
this manual programming by using CW Workbench is described.
● This is a product of Wind River Workbench is Wind River Systems, Inc. To use the Wind River Workbench, refer to the
manual for Wind River Workbench.
52
SOFTWARE PACKAGES
Q24DHCCPU
-V -VG
Version 4.01B
Version 4.09K
*2
or later
or later
Version 1.00A or later
–
Version 3.2
Version 1.91V Version 1.513K
or later or later
Version 1.60N Version 1.112S
or later or later
Version 1.63R Version 1.112S
or later or later
Version 4.02C
or later
Version
Q26DHCCPU
-LS
-LS
Version 4.03D Version 4.11M
or later or later
–
Version 1.492N Version 1.540N
or later or later
Version 1.73B
–
or later
Version 1.74C
–
or later
–
Q12DCCPU
-V
Version 4.04E
or later
Version 1.00A
or later
Version 1.00A
or later
Version 3.2
Version 1.50C
or later
Version 1.15R
or later
Version 1.17T
or later
Version 3.14Q
or later