Commissioning Checklists; Mechanical Installation Checklist; Electrical Installation Checklist - ABB ACS6000 User Manual

7.6

Commissioning checklists

This checklist is designed to help you prepare the drive and associated
equipment for commissioning.
7.6.1

Mechanical installation checklist

1) Drive is aligned according to drive layout drawing (if delivered in
several transport units) and installed according to the
instructions in this user manual (3BHS212794 E01 Rev M).
2) Drive is securely fixed to the floor.
3) Roof attachments are installed (if applicable).
4) Pipe joints are orientated and torqued correctly.
5) Joints for DC link and ground busbar are installed and
correctly torqued.
6) Roof-mounted fan units are installed (if applicable).
7) Raw water piping is completed and pipes are flanged to the
drive (if applicable).
8) Raw water supply is ready.
9) Visual inspection:
• No badly affixed or damaged components
• No foreign objects left in the cabinet
• No dirt, dust or moisture in the cabinet
7.6.2

Electrical installation checklist

1) Types and cross sections of control cables suitable for the signal
type and signal level.
2) Types and cross sections of power cables selected according to
the ABB power cable specification.
3) Pulse encoder cable shields are connected to the shield earthing
point and not connected directly to the pulse encoder interface
(applies only to drives with pulse encoder interface).
4) Cable entries prepared according to the instructions in this user
manual (3BHS212794 E01 Rev M).
5) Control cable screens and conductors are connected as
instructed in this user manual (3BHS212794 E01 Rev M), labeled
appropriately, and the customer side connections
are completed.
6) Heating cables (if supplied) is installed according to the
instructions in this user manual (3BHS212794 E01 Rev M).
3BHS212794 E01 REV M ACS6000 USER MANUAL
07 COMMISSIONING
□
□
□
□
□
□
□
□
□
□
□
□
□
□
□
170/278