Cable Duct Material; Installation Material; Floor Preparation; Raw Water Circuit - ABB ACS6000 User Manual

5.3.5

Cable duct material

▲
NOTICE
Risk of component damage!
• Use cable ducts of non-flammable material with non-
abrasive surface.
• To prevent dust, humidity and animals from entering the drive,
protect all cable entries and exits of cable ducts.
5.3.6

Installation material

Installation material is supplied with the drive in a separate box.
5.3.7 Tools
See "1.12 Tools" on page 40.
5.3.8

Floor preparation

See "Appendix C – Mechanical drawings".
5.3.9 Floor fixation
The cabinet can be bolted or welded to the floor. For more information,
see "Appendix C – Mechanical drawings".
⚠
CAUTION
Hazardous voltage!
• If you want to weld a cabinet to the floor, connect the earth clamp
of the welder to the PE ground busbar of the drive.
5.3.10

Raw water circuit

The incoming and outgoing raw water pipes are connected to the flanges
of the WCU. Installation material such as counter-flanges, bolts, nuts and
seals are supplied. For information on dimensions of the raw water entry
and the flanges, see "Appendix C – Mechanical drawings".
3BHS212794 E01 REV M ACS6000 USER MANUAL
05 MECHANICAL INSTALLATION
97/278