Table of Contents
Advertisement
22 Introduction to the manual
Quick installation and commissioning flowchart
Task
Identify the frame size: R0, R1, R2, R3 or R4.
Plan the installation.
Check the ambient conditions, ratings and required
cooling air flow.
Unpack and check the drive.
If the drive will be connected to an IT (ungrounded)
system, make sure that the internal EMC filter is not
connected.
Install the drive mechanically.
Route the cables.
Connect the power cables.
Connect the control cables.
Examine the installation.
Commission the drive.
See
Type designation key (page 32)
Guidelines for planning the electrical
installation (page 43)
Technical data (page 97)
Unpacking the delivery (page 39)
Grounding system compatibility
check (page 63)
Installing the drive (page 40)
Routing the cables (page 53)
Connecting the power
cables (page 68)
Connecting the control
cables (page 71)
Installation checklist (page 81)
Refer to
ACS180 Quick installation
and start-up guide
(3AXD50000510344
ACS180 Firmware manual
(3AXD50000467860
[English]), and
[English]).
Advertisement
Table of Contents
