Attaching The Sealing Tapes; Attach Sealing Tape To The Joining Crossbar - ABB ACS6000 User Manual

5.10

Attaching the sealing tapes

This section applies to transport units with degree of protection IP 54.
The self-adhesive sealing tape (3BHB012376R0001) supplied with the drive
(1 m per transport unit) prevents water entering the gap between two
adjoining roof plates. The tape is installed where two transport units have
been joined. Gaps within a transport unit have been sealed with a tape in
the factory.
Procedure
1. Remove the roof plates of two adjoining transport units.
2. Cut the sealing tape to the required length.
3. Attach the tape on the whole length of the joining crossbars (1).
4. Reinstall the roof plates.
3BHS212794 E01 REV M
Figure 5-21 Attach sealing tape to the joining crossbar (1)
1
ACS6000 USER MANUAL
05 MECHANICAL INSTALLATION
123/278