Lifting And Transportation; Using A Crane To Lift A Transport Unit Or The Drive By The Base Frame - ABB ACS6000 User Manual

4.5

Lifting and transportation

▲
NOTICE
Risk of component damage!
Improper lifting and transportation can damage the drive.
• Refer to "Appendix C – Mechanical drawings" before transporting
the drive. This appendix provides details on dimensions, weight,
and center of gravity of the drive.
• DO NOT lift and move the drive or a transport unit with a forklift.
• If the transport units are joined but not yet on the base frame, DO
NOT lift and move them with a crane.
- Use appropriate transport means, such as heavy load hydraulics
rollers or air cushions. If in doubt, contact ABB for instructions.
• To prevent damage to drive components, transport and move the
drive or a transport unit only in upright position.
• To prevent dirt from entering the drive, keep the doors of the drive
or a transport unit closed.
Metallic dust in particular can cause damage and failure when the
drive is energized.
4.5.1

Using a crane to lift a transport unit or the drive by the base frame

⚠
CAUTION
Tipping hazard!
• To prevent the drive or transport unit from tipping when following
these instructions, use an extra sling around the cabinet for
stabilization (Fig. 4-2).
▲
NOTICE
Risk of cabinet damage!
• Only use a crane to lift single transport units or the drive by the
base frame.
• Always observe the center of gravity!
3BHS212794 E01 REV M
04 TRANSPORTATION, STORAGE AND DISPOSAL
ACS6000 USER MANUAL 89/278