Removing An Air-To-Air Heat Exchanger; Tools For Removing An Air-To-Air Heat Exchanger - ABB ACS6000 User Manual

Depending on the drive configuration, at least one heat exchanger must
be removed for joining the DC busbars of two adjacent transport units.
3
(1) Cordless drill
(2) Wire cutter
5.8.2.1

Removing an air-to-air heat exchanger

1. Loosen the 4 self-tapping M6x12 screws (HAQN401205P0257) that
fasten the heat exchanger to the roof.
2. Remove the cable ties.
3BHS212794 E01 REV M
1
Figure 5-15 Tools for removing an air-to-air heat exchanger
(3) Torx drill bit
(4) Cable tie
ACS6000 USER MANUAL
05 MECHANICAL INSTALLATION
2
4
118/278