Digital Input Channel; I/O Port Connections - Keithley 7001 Instruction Manual

Front Panel Operation
To other three
digital outputs
Digital Output #1
Flyback Diodes
Figure 4-10
Sample externally powered relay
4.9.2

Digital input channel

The Model 7001 has one digital input channel that is
used to read a TTL input level. A TTL high on the input
will be read as "ON".
The front panel MENU feature reads the level of the
digital input channel.
4-46
Artisan Scientific - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisan-scientific.com
Model 7001
10Ω
+5V
10kΩ
Pull Up Resistor
Equivalent Circuit
Relay Coil
Flyback Diodes
Pin 3 - External Voltage Flyback
connection (+5 to +30V)
Relay Coil
(+)
(-)
Pin 4 - Digital Output #1
Pin 8 - Digital Ground
7 6
8
3
5 4
2 1
DIGITAL
OUT
(Connector J1007)
External Power
(+5V to +30V)
(+)
(-)
Transistor Switch
4.9.3

I/O port connections

The DIGITAL I/O port is located on the rear panel as
shown in Figure 4-11. This drawing also provides the
pin identification for the 8-pin micro DIN female recep-
tacle. Since the DIGITAL I/O receptacle is the same as
the TRIGGER LINK receptacle, you can use a trigger
link cable (Keithley Model 8501) to make connections.
By cutting a trigger link cable in two, it is possible to
hard-wire the unterminated end directly to an external
digital circuit.
External Power
(+5V to +30V)